User Manual
Table Of Contents
- MR400 RFID Reader Module
- Table of Contents
- About
- MR400 Integration GuideIntroduction
- InstallationMR400 RFID Reader Module, Integration GuideInstallation
- MR400 RFID Reader Module, Integration Guide
- MR400 RFID Reader Module, Integration GuideMR400 SpecificationsMR400 Specifications
- Regulatory InformationRegulatory InformationMR400 RFID Reader Module, Integration Guide
- Index
B - 4 MR400 RFID Reader Module, Integration Guide
Final Product Compliance
The MR400 is intended only for OEM integration under the following conditions:
1. The radio integration is embedded
2. The antenna must be installed such that 23 cm is maintained between the antenna and users
3. The 'Type' and 'Gain' of the antenna selected for the integration shall not exceed the figures shown in
section 1.5
As long as the 3 conditions above are met further transmitter testing will not be required.
Used outside of these conditions will trigger re-approval, Symbol advise the use of an accredited test
laboratory for advice. Be prepared, the certification process for your product may take from a few weeks to
several months.
The integrator, must determine what additional specific regulatory requirements are required of the country in
which the final product will be marketed. Final product may require non-radio frequency approvals such as
Product Safety, EMC, and SAR.