User Manual

Compliance & Regulatory Information MR 100 User Manual Page: 19
MR 100 User Manual
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
C.5. Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
C.6. Radio Frequency Interference Requirements – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Radio Transmitters
This device complies with RSS 210 of Industry & Science Canada. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Label Marking: The Term "IC:" before the radio certification only signifies that Industry Canada technical
specifications were met.
C.7
Regulatory
Symbol’s devices are designed to be compliant with rules and regulations in locations they are sold and are labeled
as required.
Any changes or modifications to Symbol Technologies equipment, not expressly approved by Symbol
Technologies, could void the user’s authority to operate the equipment.
Final Product Compliance
Final product will require Regulatory approvals; these include Product Safety, EMC, and SAR etc. As the integrator
it is your responsibility to comply with these requirements for each country in which the product is sold. The
compliance process may include submittal of prototype products for test purposes. Be prepared, the certification
process for your product may take from a few weeks to several months. Symbol advises the use of an accredited
test laboratory for advice and testing or the final product.