User's Manual

Assemble the Belt Holster
To assemble the belt holster, connect the belt to the holster grip, then connect the holster.
Connect the Belt to the Holster Grip
1
2
3
Connect the Holster to the Holster Grip
Note: The mobile computer can be placed in the holster for right or left hand
use, depending on the connection of the holster to the holster grip. The
diagram above shows a right hand connection. For a left hand
connection, reverse the holster so that the back of the holster faces
front.
Adjust the Belt
To adjust the belt size, if necessary:
1. Slide one end of the belt strap through the belt clip.
2. Pull the strap loop through, in either direction, to make the belt larger or smaller.
Wearing the Holster
Insert the Mobile Computer into the Holster
Insert the top of the mobile computer into the holster so that the RFID antenna hangs over
the front of the holster.
RFID antenna
Attach the Safety Tether
Use the safety tether to prevent the mobile computer from dropping to the floor.
To attach the tether:
1. Clip one end of the tether to the tether ring on the holster grip.
2. Clip the other end of the tether to the mobile computer’s strap. Ensure the tether is
clipped to the mobile computer’s strap loop.
1. Unsnap the two belt straps
on the holster grip and lift
the straps.
2. Align the Velcro
®
section
of the belt with the Velcro
®
section at the top of holster
grip and press together to
attach.
3. Snap the belt straps into
place over the belt.
1. Align the flat edge of the
holster grip connection post
with the flat side of the holster
connection post slot (front of
holster pictured).
2. Insert the connection post into
the connection post slot.
3. Rotate the holster, clockwise,
180°.
4. Press together the Velcro
®
sections of the holster grip and
holster to attach.
Connection
Post