User's Manual

4 - 4 MC70 User Guide
Figure 4-5 Incoming Call
To ignore the incoming call tap Ignore. This may send the caller to voice mail, depending on the service
provider. Otherwise, this presents Busy to the calling party.
To end the call tap End or press the red phone key on the EDA keypad.
Audio Modes
The EDA offers three audio modes to use during phone calls:
• Speaker Mode: Use the EDA as if on speaker phone. Tap the Speaker On button to activate this mode.
• Receiver/Handset Mode: Switches audio to the speaker at the top front of the EDA, so you can use the
EDA as a handset. To select this mode, tap Speaker Off.
• Headset Mode: Connect a headset to the headset jack to automatically switch audio to the headset.
Figure 4-6 Speaker Button
Incoming Call Features
• If you receive a call while in a call, tap Wait to place the call in call waiting.
• You can use other programs on the EDA during a call. To switch back to Phone, tap Talk or tap Start >
Phone. Tap End to end the call.
• If a caller isn't in your contact list, create a contact during the call or from Call History by tapping Menu >
Save to Contacts.
• To terminate a call when a second call comes in and answer the waiting call, tap End on the Phone
keypad to disconnect the active call, then tap
Answer or press the Send key to answer the waiting call.
• To hold the current call and answer a waiting call, tap Answer or press the Send key to place the current
call on hold and answer the incoming call.
PRELIMINARY
10/20/06