User's Manual

1 - 8 MC18 Product Reference Guide
Getting Started
To start using the MC18 for the first time:
• Install the battery
• Charge the battery.
Installing the Battery
To start using the MC18, the battery must be installed and charged.
To install the battery:
1. Using Torx T8 drive, remove two screws that secure the battery cover.
2. Lift the battery cover from the handle.
3. Guide and press the battery cable connector into the female connector inside the battery compartment.
The connector is designed to only fit one way.
4. Place the battery inside the battery compartment.
5. Place the battery cover onto the handle.
6. Secure the battery cover with the two Torx screws using a T8 Torx drive. Torque the screws to 3.6 Kgf-cm
(3.1 in-lb).
Figure 1-5 Installing the Battery
Battery Cover
Battery
Battery
Compartment
Battery
Cable
Connector