User's Manual

Cradle Installation 8 - 19
Mounting the Power Supply Unit
The power supply can be housed in an optional plastic housing, p/n PSS-3PS04-00R, to match the cradles and
hide bare power supplies and cables. This section provides the information required to mount the plastic
housing
To install the power supply unit inside the plastic housing:
1. Use the mounting template of the power supply housing to plan and mark the screw locations on the
dispenser wall.
Figure 8-27 Power Supply Housing Mounting Template
2. Feed cables through access holes in bottom housing.
3. Plug connectors into power supply.
4. Place power supply into bottom housing.
5. Place two mounting brackets over power supply and secure each mounting bracket with two screws.
NOTE The power supply unit should be mounted in landscape orientation.
Power supplies must be mounted in their natural, landscape orientation. They contain fans and their vents
must allow for the free flow of air.
IMPORTANT The power supply unit is air cooled and requires circulation of free air around it. Do not enclose it in a
small airtight enclosure other than plastic housing, p/n PSS-3PS04-00R.
UP
(View from Inside Housing)
The depth of the fully-assembled power supply decorative housing is 81.23 mm (3.198”).
10 mm
(0.394”)
38.1 mm
(1.50”)
135.9 mm
(5.35”)
115.9 mm
(4.562”)
254.0 mm
(10.00”)
68.4 mm
(2.693”)
109.4 mm
(4.307”)