User's Manual

8 - 16 MC18 Product Reference Guide
6. Secure the back covers to cradles using six T10 Torx screws (supplied) Torque screws to 6 Kgf-cm (5.2
in-lb).
Figure 8-22 Three Slot Cradle - Securing the Back Cover
7. Insert the front cover removal tool into two slots, lever upwards and pull to remove front cover from cradle.
Figure 8-23 Three Slot Cradle - Removing Front Cover
8. Position the cradle on the dispenser wall and route all interconnect cables through the access holes in the
dispenser wall.
9. Fasten the cradle to the wall using eight screws (not supplied). Ensure to use additional wall mounting
hardware, as needed, for safe mounting according to the wall type.
Figure 8-24 Three Slot Cradle - Fastening the Cradle to a Wall