User's Manual

8 - 14 MC18 Product Reference Guide
Mounting the Three Slot Cradle on a Dispenser Wall
The cradle can be bolted to a dispenser wall or any supporting furniture using eight mounting holes. The back
cover of the cradle has two access holes for routing power cables to \ from a power supply unit or adjacent
cradle. Figure 8-18 provides a mounting template for cradle installation.
Perform this procedure to mount the cradle on a dispenser wall:
1. Use the wall mount template to plan and mark the screw locations on the dispenser wall.
Figure 8-18 Three Slot Cradle - Mounting Template and Overall Depth
CAUTION DO NOT connect more than four cradles to a single power supply unit.
DO NOT connect the power supply unit to power outlet until all installation steps are completed.
NOTE The following procedure is an example installation of three slot cradles in fast charging mode - high density
configuration.
7.2 mm (0.28”)
Access Holes
Depth of cradle 125 mm (3.9”)
208.4 mm (8.2”)
312 mm (12.28”)
104.2 mm (4.1”)
13.6 mm (0.53”)
134.6 mm (5.3”)
9.1 mm (0.35”)
14.4 mm (0.56”)
15.8 mm (0.63”)
7.2 mm (0.28”)
14.4 mm (0.56”)
13.6 mm (0.53”)
9.1 mm (0.35”)