User's Manual

Cradle Installation 8 - 9
Installation of the Three Slot Cradle
Installation of the three slot cradle include the following mounting steps:
• Selecting the mounting configuration (see Mounting Configurations on page 8-9)
• Selecting the charging mode (see Charging Modes on page 8-11)
• Mounting the power supply unit (see Mounting the Power Supply Unit on page 8-19)
• Setting the cradle(s) (see Setting and Controlling the Cradle on page 6-9)
Mounting Configurations
Three slot cradles can be installed in the following mounting configurations:
• High Density (HD) configuration - Using HD cradles
• Super High Density (SHD) configuration - Using SHD cradles
• Desktop configuration - Using stand alone cradle(s) on a flat surface
High Density Configuration
The cradle can be installed in high density configuration so that the display of the MC18 units is facing the user.
In such configuration, cradles are installed in a vertical gap of 35mm between each other.
Figure 8-12 Installation in High Density Configuration
NOTE In high density configuration, the MC18 units have 10 Degrees forward-facing tilt that should be taken in consideration
if furniture is planed to be placed in front of the dispenser wall.
35mm