User Manual

Quick Reference
2
Ready, Test, Scan
Ready
Make sure connections are secure, and the battery pack is
charged. The battery must be charged before the scanner’s
initial use, and after each day’s use. Placing the scanner in its
base station between uses will help maintain the battery’s
charge.
Be sure the scanner is “paired” to the base station by
scanning the Pairing bar code on the base.
Test
Aim the scanner away from you and press the trigger.
When you press the trigger, the scanning beam is energized
for approximately 3.0 seconds (default).
Scan
Make sure the symbol you want to scan is within the
scanning range. See the LS 4071 Product Reference Guide .
Also, be certain the scanner is within range of the base
station: 10 feet (3 meters).
The scanner has read the symbol when:
• The yellow LED on the rear of the scanner turns green
for a short period of time after the scanning beam turns
off.
The data has been successfully sent to the base station when:
• You hear a short, high tone beep from the base (if
default beeper settings are selected).
• The yellow LED on the base blinks.