User's Manual

SPS 3000

SCAN/LAN

Note: A fully discharged battery should recharge in approxi-

mately 2.5 hours. There is no indication that the battery

is charging or is fully charged. The iPAQ must be used

to check the battery status.

2. Once battery is fully charged, the external power from the AC

adapter can be removed.

Expansion Pack Connected to an iPAQ

1. Insert the power plug from the AC adapter into the power

jack on the iPAQ or on the expansion pack, or place the two

units into a cradle that has the AC adapter power plug con-

nected.

2. The battery in the expansion pack will begin to charge only

after the battery in the iPAQ has become fully charged. The

iPAQ battery takes approximately 2.5 hrs. to charge when

fully discharged.

3. From the "Power" screen, the state of the expansion pack

battery can be found under the "External battery:" entry.

4. The expansion pack, when being charging, will have "Re-

charging state:" and "Charging" state immediately above the

bar graph on the iPAQ charging screen.

Note: Note that the bar graph will be continuously stepping

from 0 to 100% as the battery is charging.

5. Once the expansion pack battery is completely charged, the

entry above the bar graph will change to read "Battery power

remaining:" and the bar graph will be filled to 100%.

6. Once the expansion pack battery is completely charged, the

external power from the AC adapter can be removed.

Inserting the iPAQ into the SPS 3000

1. Slide the iPAQ through the SPS 3000 sleeves to connect the

iPAQ and SPS 3000.