User's Manual

10
SPS 3000
SCAN/LAN
Maintaining the SPS 3000
For trouble-free service, follow these tips when using your SPS 3000:
• Do not scratch the exit window.
• The exit window of your SPS 3000 contains glass. Do not subject it
to any strong impact.
• Protect your SPS 3000 from temperature extremes, hot or cold:
- Do not leave it on the dashboard of a car on a hot day
- Keep it away from heaters and other heat sources
- Keep it away from freezers and other cold sources.
• Do not store or use your SPS 3000 in any location that is
extremely dusty, damp or wet.
• If the surface of the SPS 3000 exit window becomes soiled, clean it
with a soft lens cloth moistened with a diluted window-cleaning so-
lution.
Ergonomic Recommendations
Caution: In order to avoid or minimize the potential risk of ergonomic injury follow the recommendations below. Consult
with your local Health & Safety Manager to ensure that you are adhering to your company’s safety programs to prevent
employee injury.
• Reduce or eliminate repetitive motion
• Maintain a natural position
• Reduce or eliminate excessive force
• Keep objects that are used frequently within easy reach
• Perform tasks at correct heights
• Reduce or eliminate vibration
• Reduce or eliminate direct pressure
• Provide adjustable workstations
• Provide adequate clearance
• Provide a suitable working environment
• Improve work procedures.
Regulatory Information
Radio Frequency Interference Requirements
T
his device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the
Federal Communications Commissions Rules and Regulation. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.