User's Manual

9
Quick Reference
Attaching the Lanyard
Scanning Bar Codes
To scan bar codes with the SPS 3000:
1. Insert the iPAQ into the SPS 3000.
2. Press the scan trigger to launch the scanning application.
3. Press and hold the scan trigger again to turn on the laser.
4. Ensure that the red scan beam covers the entire bar code.
Upon successful decode, you will see the Power LED blink
green and hear an audible beep.
Thread the lanyard through the
handstrap connector on the back of
the scanner, leaving a loop to pull the
long end of the lanyard
Thread the long end of the lanyard
through the loop and pull.
Scan Trigger
(Default)