User's Manual

Quick Reference Guide 7
complete charge takes up to 4 hours, depending upon the remaining charge in the
battery.
Charging LED
Once the scanner is placed in the cradle, it waits 15 minutes to start charging the
battery in the scanner. The LED indicates the charging status as follows:
Troubleshooting
If the cradle does not work after following the operating instructions in this guide:
• check the system power.
• check for loose cable connections.
• ensure the scanner is sitting properly in the cradle.
Cleaning
Wipe the cradle periodically with a lens tissue or other material suitable for
cleaning optical material, such as eyeglasses.
Regulatory Information
All Symbol devices are designed to be compliant with rules and regulations in locations they are sold
and are labeled as required.
Any changes or modifications to Symbol Technologies equipment, not expressly approved by Symbol
Technologies, could void the user's authority to operate the equipment.
Do NOT attempt to charge damp/wet mobile computers or batteries. All components must be dry
before connecting to an external power source.
Country Approvals
Regulatory markings are applied to the device signifying the radio (s) are approved for use in the
following countries: United States, Canada, Australia, Japan and Europe.
Please refer to the Symbol Declaration of Conformity (DoC) for details of other country markings.
This is available at http://www2.symbol.com/doc/.
Operation of the device without regulatory approval is illegal.
LED Description
Off The scanner is not in the cradle.
Slow Blink Scanner is in cradle but not charging.
Fast Blink Scanner is in cradle and charging.
On Scanner is in cradle and the charge cycle is
complete.
CAUTION Do not pour, spray or spill any liquid on the cradle.
CAUTION Only use Symbol approved and UL Listed accessories, battery packs and
battery chargers.

