User's Manual

6 EMG101 Gateway
1.3 Site Preparation
To prepare your deployment site for gateway installation:
• Consult your site survey and network analysis reports to determine specific equipment placement, power
drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify and document where all installed components are located
• Ensure adequate, dust-free ventilation to all installed equipment
• Prepare Ethernet port connections
• Verify cabling is within the maximum 100 meter allowable length
1.4 Package Contents
The EMG101 Gateway ships with the following:
• ESL101 Gateway
• Installation Guide (This Guide)
• Rubber Wall Mount Spacers (4)
• Wall mount screw and anchor kit
1.5 Features
• One RJ-45 console connector
• LED indicator
• Safety wire tie point
• Wall mount slots
• Clips for suspended T-Bar mounting
• DC power connector
An EMG101 Gateway has one RJ-45 connector supporting an 10/100/1000 Ethernet port connection and requires
802.3af compliant power from an external source.
The EMG101 Gateway contains runtime firmware which enables the unit to boot after either a power up or a
watchdog reset. The runtime firmware on the gateway can be updated via the Ethernet interface.
MN000995A01.fm Page 6 Tuesday, August 26, 2014 2:27 PM