User's Manual
Table Of Contents
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
6 CS4070 Scanner
Charging Spare Batteries
1. Connect the single-slot cradle or 8-slot
spare battery charger to power.
2. Insert the battery into a spare battery slot
with the charging contacts facing down,
contacting the charging pins in the cradle.
The charge LED on the cradle lights to show
the charge status.
Connecting to a Host
Batch Connection
The micro USB cable enables communication
between the CS4070 and a PC, and charges
the battery in the CS4070.
See Charging via USB Host Cable on page 4
for connection instructions.
Bluetooth Connection
Pairing
The CS4070 supports Serial Port Profile (SPP)
and Human Interface Device (HID) protocols.
Note To enter batch scanning mode, the
scanner cannot be paired to a
Bluetooth host.