User's Manual
Table Of Contents
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
4 CS4070 Scanner
Charging
Before using the CS4070 for the first time,
charge the battery using the micro USB cable
or a cradle until all four green charging LEDs
light. Charge time is approximately three hours
for a fully discharged battery.
Charging via USB Host Cable
1. Insert the micro USB connector on the
cable in the interface port on the scanner.
2. Connect the other end of the host cable to
a USB port on the host PC, or to a USB
power adapter plugged into an AC outlet.