User's Manual
Table Of Contents
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
Quick Reference Guide 11
Scanning
To scan a bar code:
1. Aim the scanner at the bar code.
2. Press the scan (+) button.
3. Ensure the aiming dot is centered on the
bar code.
The scanner beeps and the LED turns green to
indicate a successful decode. See User
Indications for beeper and LED definitions.
Note The scanner cannot scan bar codes
when it is connected to the host via
the USB cable.