User's Manual

22
d. Click the ICMP Ping Test button. Results of the ping test displays on the Status line. If
the Status line displays Success, the CB3000 can interoperate with its associated
access point. Proceed to Where to Go From Here? on page -22.
Where to Go From Here?
Once basic connectivity has been verified, the CB3000 can be fully configured to meet the needs of
the network and the users it supports. The sections referenced below are located within the CB3000
Client Bridge User Guide available on your product CDROM or from the Symbol Web site
(http://www.symbol.com/services/downloads).
• Refer to Chapter 4 for configuring CB3000 network address information, operational
mode information, Adhoc mode values, SNMP parameters, Network Time Protocol
(NTP), restore the factory configuration, import/export CB3000 configurations, update
device firmware, view the CB3000 log or Troubleshoot the CB3000.
• Refer to Chapter 5 for detailed information on configuring specific encryption (WEP,
WPA1 and WPA2) and authentication (Secure 802.1x) security schemes.
• Refer to Chapter 6 for information on accessing statistics helpful in monitoring the
connection between the CB3000 and its connected devices.
CB3000 Troubleshooting
Symbol recommends the following troubleshooting tips before contacting the Support Center:
Problem Corrective Action
PWR LED is Off or
Orange
Verify only the supplied power adapter is used and is plugged into a power supply
appropriately rated for the country of operation.
Unplug the power adapter and re-insert it back into the power outlet. If the problem
persists, a hardware problem likely exists. Contact the Symbol Customer Support.
LAN LED is Off
Verify the cable connection is secure between the CB3000 and the PC’s LAN port.
Ensure the computer network card is functioning properly.