User's Manual
Table Of Contents
- CB3000 Overview
- Installing the CB3000
- Prerequisite Requirements
- Verifying the Package Contents
- Verifying the Installation Site
- Installing the CB3000
- Displaying the CB3000 User Interface
- Connecting to the User Interface Using a Web Browser
- Connecting to the User Interface Using the Discovery Tool
- Configuring CB3000 WLAN Settings
- Configuring CB3000 Ethernet Settings
- Configuring CB3000 Security
- Configuring CB3000 Basic Encryption
- Testing Device Connectivity
- Where to Go From Here?
- CB3000 Troubleshooting
- Technical Specifications
- Customer Support
- Regulatory Compliance
CB3000 Client Bridge Install Guide
19
3. Use the Authentication Type drop-down menu to specify whether a shared key is
implemented between the CB3000 and its associated device or no key is used
(Open System).
If a shared key is used, both the CB3000 and its connected device are required to use the
same single key (as selected from 1 to 4) to interoperate. A shared key increases the level
of security within the network as opposed sending information without one (Open System).
4. Use the Default Transmit Key checkboxes to specify which one key is used to transmit
WEP algorithm information between the CB3000 and its connected device.
NOTE The CB3000 and its networked device are required to use the same key
and key length to interoperate.