User Manual Part 3
Table Of Contents
- Network Management
- Configuring Access Point Security
System Configuration
4-23
Use the SNMP Access Control screen's Access Control List (ACL) to limit, by Internet Protocol (IP)
address, who can access the access point SNMP interface.
To configure SNMP user access control for the access point:
1. Select System Configuration - > SNMP Access from the access point menu tree. Click
on the SNMP Access Control button from within the SNMP Access screen.
2. Configure the SNMP Access Control screen to add the IP addresses of those users receiving
SNMP access.
NOTE The ACL applies to both SNMP v3 user definitions and SNMP v1/v2c
community definitions on the access point SNMP Access screen.