User Manual Part 3

Configuring Access Point Security
6-37
5. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the VPN, Auto Key Settings, IKE Settings and Manual Key Settings
screens to the last saved configuration.
6. Click Logout to securely exit the access point Symbol Access Point applet. A prompt
displays confirming the logout before the applet is closed.
6.11.1 Configuring Manual Key Settings
A transform set is a combination of security protocols and algorithms applied to IPSec protected
traffic. During security association (SA) negotiation, both gateways agree to use a particular
transform set to protect data flow.
A transform set specifies one or two IPSec security protocols (either AH, ESP, or both) and specifies
the algorithms to use for the selected security protocol. If you specify an ESP protocol in a transform
set, specify just an ESP encryption transform or both an ESP encryption transform and an ESP
authentication transform.
When the particular transform set is used during negotiations for IPSec SAs, the entire transform set
(the combination of protocols, algorithms, and other settings) must match a transform set at the
remote end of the gateway.
Use the Manual Key Settings screen to specify the transform sets used for VPN access.
To configure manual key settings for the access point:
1. Select Network Configuration -> WAN -> VPN from the access point menu tree.
2. Refer to the VPN Tunnel Config field, select the Manual Key Exchange radio button and
click the Manual Key Settings button.