User Manual Part 3
Table Of Contents
- Introduction
- 1.1 New Features
- 1.2 Feature Overview
- 1.2.1 Single or Dual Mode Radio Options
- 1.2.2 Separate LAN and WAN Ports
- 1.2.3 Multiple Mounting Options
- 1.2.4 Antenna Support for 2.4 GHz and 5.2 GHz Radios
- 1.2.5 Sixteen Configurable WLANs
- 1.2.6 Support for 4 BSSIDs per Radio
- 1.2.7 Quality of Service (QoS) Support
- 1.2.8 Industry Leading Data Security
- 1.2.9 VLAN Support
- 1.2.10 Multiple Management Accessibility Options
- 1.2.11 Updatable Firmware
- 1.2.12 Programmable SNMP v1/v2/v3 Trap Support
- 1.2.13 Power-over-Ethernet Support
- 1.2.14 MU-MU Transmission Disallow
- 1.2.15 Voice Prioritization
- 1.2.16 Support for CAM and PSP MUs
- 1.2.17 Statistical Displays
- 1.2.18 Transmit Power Control
- 1.2.19 Advanced Event Logging Capability
- 1.2.20 Configuration File Import/Export Functionality
- 1.2.21 Default Configuration Restoration
- 1.2.22 DHCP Support
- 1.2.23 Multi-Function LEDs
- 1.3 Theory of Operations
- Hardware Installation
- Getting Started
- System Configuration
Getting Started
3-5
The export function will always export the encrypted Admin User password. The import
function will import the Admin Password only if the access point is set to factory default. If
the access point is not configured to factory default settings, the Admin User password WILL
NOT get imported.
.
3.3.1 Configuring Device Settings
Configure a set of minimum required device settings within the Quick Setup screen. The values
defined within the Quick Setup screen are also configurable in numerous other locations within the
menu tree. When you change the settings in the Quick Setup screen, the values also change within
the screen where these parameters also exist. Additionally, if the values are updated in these other
screens, the values initially set within the Quick Setup screen will be updated.
To define a basic access point configuration:
1. Select System Configuration -> Quick Setup from the menu tree, if the Quick Setup
screen is not already displayed.
2. Enter a System Name for the access point.
The System Name is useful if multiple Symbol devices are being administered.
3. Select the Country for the access point’s country of operation from the drop-down menu
The access point prompts the user for the correct country code on the first login. A warning
message also displays stating that an incorrect country settings may result in illegal radio
operation. Selecting the correct country is central to legally operating the access point. Each
country has its own regulatory restrictions concerning electromagnetic emissions and the
maximum RF signal strength that can be transmitted. To ensure compliance with national
and local laws, be sure to set the Country accurately. CLI and MIB users cannot configure
their access point until a two character country code (for example, United States - us) is set.
Refer to Appendix A, Country Codes on page A-7 for the two character country codes.
NOTE Though the access point can have its basic settings defined using a
number of different screens, Symbol recommends using the access point
Quick Setup screen to set the correct country of operation and define its
minimum required configuration from one convenient location.
NOTE The System Name and Country are also configurable within the System
Settings screen. Refer to Configuring System Settings on page 4-2 (if
necessary) to set a system location and admin email address for the
access point or to view other default settings.