Manual
Table Of Contents
- Introduction
- Parts of the Series 3100 Terminal
- Power On and Off
- 31XX Cradles
- Replacing the Batteries
- Connecting the Modems
- Acoustic
- Connecting the Terminal to a Printer
- Using the Integrated Laser Scanner
- Connecting and Using a Tethered Scanner
- IEC825/EN60825 Class 1 Scanner
- Introduction
- Composants du terminal 3100
- Marche/arrêt
- Puits de chargement 31XX
- Remplacement des piles
- Raccordement des modems
- Raccordement du terminal à une imprimante
- Utilisation du lecteur laser intégré
- Branchement et utilisation d'un lecteur raccordé par câble
- Lecteur IEC825/EN60825 classe 1
- Einführung
- Teile des Terminals der Serie 3100
- Ein- und Ausschalten
- 31XX Cradle
- Austauschen der Batterien
- Anschließen des Terminals an einen Drucker
- Benutzen des integrierten Laserscanners
- Anschließen und Benutzen eines Handscanners
- IEC825/EN60825 SCANNER, KLASSE I
- Introduzione
- Componenti del terminale Serie 3100
- Accensione e spegnimento
- Cradle 31XX
- Sostituzione delle batterie
- Collegamento con modem
- Modem acustico
- Collegamento del terminale ad una stampante
- Uso del lettore laser integrato
- Collegamento ed uso di un lettore a filo
- Lettore Classe 1 IEC825/EN60825
- Introducción
- Componentes del terminal de la serie 3100
- Encendido y apagado
- Soportes 31XX
- Sustitución de las baterías
- Conexión de un módem
- Módem acústico
- Conexión del terminal a una impresora
- Empleo del scanner láser integrado
- Conexión y uso de un scanner independiente
- Scanner IEC825/EN60825 de clase 1
- Service Information
19
Connecting and Using a Tethered Scanner
To attach a wand or laser scanner to the Series 3100 terminal:
1. Turn the system off.
2. Remove the plastic cap in the top of the terminal.
3. Plug the scanner into the top of the terminal as shown
below.
4. Aim the scanner at the bar code and press the trigger.
Note: Depending on your application, you may need to turn on
the terminal before using the scanners.
5. If using a wand scanner, lightly touch the scanner tip to
the white space at the left side of the bar code and move it
to the right.