Manual
Table Of Contents
- Introduction
- Parts of the Series 3100 Terminal
- Power On and Off
- 31XX Cradles
- Replacing the Batteries
- Connecting the Modems
- Acoustic
- Connecting the Terminal to a Printer
- Using the Integrated Laser Scanner
- Connecting and Using a Tethered Scanner
- IEC825/EN60825 Class 1 Scanner
- Introduction
- Composants du terminal 3100
- Marche/arrêt
- Puits de chargement 31XX
- Remplacement des piles
- Raccordement des modems
- Raccordement du terminal à une imprimante
- Utilisation du lecteur laser intégré
- Branchement et utilisation d'un lecteur raccordé par câble
- Lecteur IEC825/EN60825 classe 1
- Einführung
- Teile des Terminals der Serie 3100
- Ein- und Ausschalten
- 31XX Cradle
- Austauschen der Batterien
- Anschließen des Terminals an einen Drucker
- Benutzen des integrierten Laserscanners
- Anschließen und Benutzen eines Handscanners
- IEC825/EN60825 SCANNER, KLASSE I
- Introduzione
- Componenti del terminale Serie 3100
- Accensione e spegnimento
- Cradle 31XX
- Sostituzione delle batterie
- Collegamento con modem
- Modem acustico
- Collegamento del terminale ad una stampante
- Uso del lettore laser integrato
- Collegamento ed uso di un lettore a filo
- Lettore Classe 1 IEC825/EN60825
- Introducción
- Componentes del terminal de la serie 3100
- Encendido y apagado
- Soportes 31XX
- Sustitución de las baterías
- Conexión de un módem
- Módem acústico
- Conexión del terminal a una impresora
- Empleo del scanner láser integrado
- Conexión y uso de un scanner independiente
- Scanner IEC825/EN60825 de clase 1
- Service Information
13
Connecting the Modems
Direct Connect
Some terminals use an optional internal modem that communicates at
rates of up to 14,400 bps (with v.32 bis data compression). There are
specific firmware settings which are used to configure the
modem’s hardware and software for proper operation and
regulatory compliance. The terminal’s application can control
these settings and enable you to view and amend the settings for
country/region, pulse/tone dialing, or repeat dial timing.
Incorrectly defining these settings can lead to illegal use of the
modem and can create unreliable operation. The application
developer should consult the Series 3000 Application
Programmer’s Reference Manual for correct settings.
If your terminal is equipped with a direct connect modem,
connect the modem as follows:
1. Turn the terminal off.
2. Release the hand strap on the back of the terminal.