Operation Manual

7. Use of each component
9
CAUTION:
Do not wipe plastic components, e.g. instrument panel, headlight, with organic solvents such as
gasoline…etc to avoid damaging these components.
Speedometer
This shows your speed in kilometers per hour (km/h or mile/h).
On “ODO” mode, push “SET” and “MODE” button for two seconds to switch between “km” and “mile”
display. (If installed)
Short-press on the button S shows the highest speedometer record.
Under the highest record mode, long-press on the buttonSand the highest speedometer record can be
deleted.
Odometer
This odometer shows the total kilometers this motor has been driven.
Trip odometer :
The rider can measure the trip odometers. It shows four digits; 3 in kilometers and 1 in hundred meter.
(The trip odometer will return to zero if its measurement is over 1000 kilometers or turn the reset knob.)
Fuel gauge
The fuel gauge doesn’t come on when the main switch is at “OFF” position.
When key switch is turned to “ON”, and the “pointer” also in “E” position (red area). Refuel octane 92/95
unleaded gasoline immediately.
High Beam Indicator
This indicator comes on with high beam headlight is turned on.
Turn Signal Indicator
The left or right Indicator will be flashing according to the operated directions of turn signal light switch
when it is turned on.
Transmission neutral Indicator
This indicator show transmission neutral.
Tachometer
Rotational speed of the engine.
Engine Coolant Temperature indicator :(T2)
Indicates the status of engine coolant temperature
If the coolant temperature warning indicator stays ON while the engine running,
Stop engine and check radiator coolant level and the fan motor.
Shift position indicator:(T2)
shows the current status of shift lever position.
Side stand warning indicator:(T2)
As long as the side stand is not up, the indicator light comes ON and the engine can be started in
neutral. But the engine will be off or stop running with shifting the transmission in gearThe sidestand
should be up and the indicator light is off as well, the engine could be started when the transmission is in
gear.