Operation Manual
10. Inspection and maintenance before riding
27
STEERING HANDLE FRONT SHOCK ABSORBERS INSPECTION
Perform this check with engine shut off and ignition switch
key removed.
Visual check front shock absorbers for damage.
Operate steering handle up and down, and check front
shock absorbers for noises due to bends.
Check the bolts and nuts of front shock absorbers with
wrenches for tightness.
Shake steering handle up & down, left & right, and front &
rear to check if it is loosen, has too much resistance and
pulls to one side.
Check steering handle if it is being pulled too tight by
the brake cables.
Take your motorcycle to SYM Authorized Dealer or
Franchised Dealer for a check or adjustment if any
abnormal conditions are found.
CHECING THE LUBRICATION OF BODY’S VARIOUS MECHANISMS
Check the body’s pivot points if they have enough lubrication.
(For example, the pivot points on the main stand, the side stand, and the brake lever…etc.)
BACK MIRROR
Sit on seat, check and make sure the image of the back mirrors is suitable.
LICENSE PLATE (If installed)
Check the license plate for dirt and injury, make sure it is secure.
COOLING SYSTEM INSPECTION
(Checking coolant lever)
1. Support vehicle with main stand on a level ground.
2. Check reserved tank from viewing window to see if
coolant level is between the upper limit and lower
limit mark.
3. Add coolant up to upper mark if coolant is close to
the lower mark.
(Check the cooling system for leakage)
• Check radiator and piping for leakage.
• Check the ground where the vehicle is parked for water
dripped from the vehicle.
REPLENISHMENT OF COOLANT
Always keep radiator cap tightly closed.
1. Support vehicle on a level ground in a straight up position.
2. Open the battery cabinet door.
3. Open surge tank cap, refill coolant until reaches the upper mark.
• If coolant level becomes too low and occurs too often, it may
indicate there is something wrong with the coolant system.
• To avoid radiator getting rusty, do not use coolants other than those recommended.
Coolant recommended: SYM Bramax radiator agent Concentration: 50%
Upper limit
Lower limit
Coolant
filler cap