Operation Manual

7. Use of each component
10
Engine Oil Replacement Indicator
Engine oil replacement indicator light will illuminate when the vehicle is ridden for approx. 1,000 km, which
means the engine oil should be checked or replaced.
Key on and press the “M” button for at least two seconds after replacing the engine oil, engine oil
replacement indicator light will extinguish.
Mileage Setting
1. Showing total distance and trip distance.
2. Key on and press the “M” button shortly to switch from odometer, tripmeter, clock and voltage gauge.
3. Press the “S” button for at least two seconds under tripmeter mode, the trip mileage can be erased.
Clock Setting
1. Showing 24-hour clock system.
2. After the main switch is on, the clock will show hour and minute.
3. Under the clock mode and the vehicle is still, press the “S” button for at least two seconds to enter
clock setting mode. Under the clock setting mode, press the “S” button shortly to switch setting item
(hour → tens digit of minute → units digit of minute). Press the “M” button shortly to increase the digit.
Under the clock setting mode, press the “S” button for at least two seconds to complete clock setting.
Hour Minute (tens digit) Minute (units digit)
Battery Voltage Display
1. Showing the battery voltage.
2. After the main switch is on, the battery voltage will show at least 10 seconds and then clock shows.
CAUTION:
 If the battery voltage is below 10.0V when the main switch is on, the light system is off and the engine is
not started, check the battery at SYM dealer.
 If the battery voltage is below 10.0V or over 16.0V when the vehicle is moving, check the battery at SYM
dealer.
TOTAL
CLOCK
T
RIP
CLOCK
T
RIP
VOLTAGE