Installation Instructions

8. V-Belt Drive System
8-2
Precautions in Operation
General Information
 Drive face, clutch outer, and driven pulley can be serviced on the motorcycle.
 Drive belt and drive pulley must be free of grease.
Specification
Item Standard value Limit
Drive belt width 24.000 mm 22.500 mm
OD of movable drive face boss 29.946~29.980 mm 29.926 mm
ID of movable drive face 30.000~30.040 mm 30.060 mm
OD of weight roller 19.500~20.000 mm 19.000 mm
ID of clutch outer 144.850~145.150 mm 145.450 mm
Thickness of clutch weight 6.000 mm 3.000 mm
Free length of driven pulley spring 102.400 mm 97.400 mm
OD of driven pulley boss 40.950~40.990 mm 40.930 mm
ID of driven face 41.000~41.050 mm 41.070 mm
Weight of weight roller 17.700~18.300 g 17.200 g
Torque value
 Drive face nut: 8.5~10.5kgf-m
 Clutch outer nut: 5.0~6.0kgf-m
 Drive plate nut: 5.0~6.0kgf-m
Special Service Tools
Clutch spring compressor: SYM-2301000
Inner bearing puller: SYM-6204002
Clutch nut wrench 39 x 41 mm: SYM-9020200
Universal holder: SYM-2210100
Bearing driver: SYM-9100100
Troubleshooting
Engine can be started but motorcycle can
not be moved
1. Worn drive Belt
2. Worn drive face
3. Worn or damaged clutch weight
4. Broken driven pulley
Shudder or misfire when driving
1. Broken clutch weight
2. Worn clutch weight
Insufficient horsepower or poor high
speed performance
1. Worn drive belt
2. Insufficient spring force of driven pulley
3. Worn roller
4. Driven pulley operation un-smoothly
To this chapter contents