Operation Manual

7. USE OF EACH COMPONENT

USE OF BUTTONS

y Light Switches

When the switch is turned to this position as the engine

is being started, headlight, rear light, instrument panel

light, and position light will come on.

When the switch is turned to this position as the

engine is being started, rear light, instrument panel

light, and position light will come on.

When the switch is turned to this position, all lights

will go off.

• Electrical Starter Button

This is a starting motor button (switch) for engine starting.

With the main switch "ON", press this button while holding the front or rear brake lever will

start the engine.

• High/Low Beam Switch

This is the high and low beam of headlight switching switch. Press this switch to switch between high

and low beams.

This is for high beam.

This is for low beam. (Please turn to low beam when riding in city)

• Passing Switch

Turn ignition switch “ON” and press this button down. Then, the high beam of headlight

will come on immediately to warn the driver of the vehicle ahead that you intend to

overtake him/her. (For overtaking, high beam indicator will come on at this time) This

button will return to original position after releasing.

PASSING

Light Switches

Electrical Starter

Button

High/Low Beam Switch

Turn Signal Switch

Horn Switch

Passing switch

Note:

y Position Light Function:

This light can indicate the

motorcycle’s position when the

motorcycle is running in dim,

rainy, or foggy weather.

CAUTION:

• Release this button immediately after engine has been started, and never press the button

again to avoid damaging the engine.

• This mechanism is a safety design. The engine can only be started after the front or rear brake

lever (pedal) has been applied.

• Do not use light system. Turn headlight and turn signal lights to the “OFF” position when the

engine is being started.