Operation Manual

11
7. USE OF EACH COMPONENT
FUEL TANK CAP 【Fuel refilling】
1. Insert ignition switch key into the lock on the fuel tank cap,
and turn the key to the left, then the cap can be removed.
2. Do not fill over the fuel upper limit when refueling.
3. Align the “△” mark on the cap to the right or left, and turn the
key to the right cap in parallel until the cap is locked.
Remove the ignition key.
BRAKE
y Use front and rear wheel brakes simultaneously when braking.
y Avoid unnecessary sudden braking as this may lead to the wheels locking and the scooter going out of
control.
y Using only the front brake or the rear brake increases the risk of falling because the scooter is tend to
pulled to one side.
y Avoid applying the brakes continuously for a long period of time because that may overheat the brakes
and reduce its braking efficiency.
y Slow down and brake early when riding in rainy days on slippery roads. Never apply the brakes
suddenly to prevent skidding and falling.
《Engine Brake》
Return the throttle valve handle back to its original position, and apply engine brake.
It is necessary to apply both brake and engine brake intermittently when riding on a long or stiff slope.
For Rear Wheel For Front Wheel
WARNING:
y Use caution when refueling! Keep lit cigarettes and other flames away from the scooter
and fuel source!
y To refuel: 1) Shut off engine, 2) Set scooter up on main stand, 3) Open fuel tank cap, 4) Fill fuel
tank.
y Do not fill fuel tank above upper limit of fuel tank when refueling. If fuel tank is overfilled, fuel will
flow out through a hole on the fuel tank cap. This could result in a fire and/or damage to the
scooter.
y Make sure the fuel tank cap has been properly tightened after refueling and before riding the
scooter.
y Do not sill fuel on exhaust pipe as it may ignite and cause a fire, and resulting injury.