Operation Manual

10
7. USE OF EACH COMPONENT
• Horn Switch
Press this button down when ignition switch is in
the “ON” position to sound, the horn.
• Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to “ON”, and slide the turn signal switch to left or right. Then, the turn signal lights will
flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
SAFETY HELMET HOOK
y Open the seat, and hook the safety helmet chin belt onto the hook, and then lock the seat.
SEAT LOCK
• Unlock:
Insert the ignition switch key to the seat lock and turn to left to unlock.
• Lock:
Press the seat down and it will be locked automatically.
After the seat has been locked, check to make sure it has been locked properly by lightly lifting the seat.
LUGGAGE BOX
y This box is located under the seat.
y Maximum load capacity: 10kg.
y Do not store valuables in the box.
y Please make sure that seat cushion had been locked completely after it was down.
y Take out valuables before washing to avoid wetting these objects.
y Do not place thermal sensitive objects in the box because of engine’s heat and high temperature.
NOTICE:
y Do not press the horn button when
you are in the no horn area.
WARNING:
y Never hang your safety helmet on the helmet hook while riding. Doing so could interfere with
your riding safety and could damage the scooter.
CAUTION:
y Do not put the scooter key in the luggage box compartment after seat has been unlocked. This
will prevent the key from being locked inside the luggage compartment if the seat should be
unintentionally closed.
y Be sure to remove the key after the seat has been locked.