Operation Manual

• Electrical Starter Button

This is a starting motor button (switch) for engine starting.

With the main switch "ON", press this button while holding the front or rear brake lever will

start the engine.

CAUTION:

• Release this button immediately after engine has been started, and never press the button again

to avoid damaging the engine.

• This mechanism is a safety design. The engine can only be started after the front or rear brake

lever (pedal) has been applied.

• Do not use light system. Turn headlight and turn signal lights to the “OFF” position when the

engine is being started.

• High/Low Beam Switch

This is the high and low beam of headlight switching switch. Press this switch to switch between high

and low beams.

This is for high beam.

This is for low beam. (Please turn to low beam when riding in city)

• Passing Switch

Turn ignition switch “ON” and press this button down. Then, the high beam of headlight will

come on immediately to warn the driver of the vehicle ahead that you intend to overtake him/her.

(For overtaking, high beam indicator will come on at this time) This button will return to original

position after releasing

• Horn Switch

Press this button down when ignition switch is in the “ON” position, the horn will sound.

CAUTION:

Do not press this button when you are in the area where there’s no honking.

Hazard Switch

The main switch in the〝 ON 〞 position, cuts

according to this switch, four directions

lantern festivals dodge extinguish do move,

also can simultaneously dodge on the

display board direction indicating lamp

extinguishes does moves. If stops the

vehicle has when the transportation

frequent dangerous position or the vehicle

the breakdown, may use the dangerous

police to show the switch.

The main switch in the〝 ON 〞 position,

hazard switch only then may close.

7. Use of each component