Installation Instructions

8. V-Belt Driving System
8-9
With 4~5g grease spreads wipes drives in the
movable drive face axis hole.
Install drive face boss.
Caution
y The movable drive face surface has to be free
of grease. Clean it with cleaning solvent.
Install movable drive face comp. onto crankshaft.
Driven pulley installation
Press drive belt into pulley groove, and then pull
the belt onto drive shaft.
Install drive face, washer and nut.
Caution
y Make sure that two sides of pulley surfaces
have to be free of grease. Clean it with
cleaning solvent.
Hold drives face with universal holder.
Tighten nut to specified torque.
Torque value: 8.5~10.5kgf-m
Install left crankcase cover.
Drive face boss
Crank shaft
Drive face boss
Movable drive face
Drive belt
Press down
To this chapter contents