Installation Instructions

8. V-Belt Driving System

8-6

Installation

Caution

● Pull out driven face to avoid it closing.

● Cannot oppress friction plate comp in order to

avoid creates the distortion or the damage.

Install drive belt onto driven pulley.

Install the driven pulley that has installed the belt

onto drive shaft.

On the drive belt another end to the movable drive

face.

Install the clutch outer and bearing stay collar.

Hold the clutch outer whit universal holder, and

then tighten nut to specified torque value.

Torque value: 5.0~6.0kgf-m

Install the drive face, washer and drive face nut.

Hold drive face with universal holder, and then

tighten nut to specified torque value.

Torque value: 8.5~10.5kgf-m

Driven face

To this chapter contents

Universal holder

Bearing stay collar