Operation Manual

6
CAUTION:
Do not wipe plastic components, e.g. instrument panel, headlight, with organic solvents such as
gasoline…etc to avoid damaging these components.
The panel figure for speedometer may vary from model to model, but the location usually are the
same.
7.
USE OF EACH COMPONENT
(The following is SYM 4 stroke air-cooling scooter’s basic operation, and they could vary
from different individual models. Please consult the end of this manual.)
§GAUGES§
 Speedometer：
Indicates driving speed.
 Odometer：
Indicates total accumulated distance traveled.
 High Beam Indicator：
This indicator comes on with high beam
headlight is turned on.
 Turn (left/right) Signal Indicator：
The left or right Indicator will be flashing
according to the operated directions of turn
signal light switch when it is turned on.
 Fuel Meter:
The pointer in this meter shows how much
fuel remains in the tank.
The pointer stays in “E” position when key
switch is turned to “OFF”.
1.“S” button:
Press“S” button about one or two seconds to switch to voltage display. Return to time display
automatic about one minute later, or press“S” button short time to return to time display
immediately.
2.“M” button:
a. Press“M” button for long time to enter hour adjustment, then hour display will flash. Press“S”
button to adjust hour, and press“M” button shortly to switch to minute adjustment. At this time
minute display will flash. Press“S” button shortly to increase a minute, press“S” button long time
minute figure will automatically be increased continuously.
b. After adjust time well, press“M” button for long time to exit setting state, or wait for about 1 ~ 2
minutes to exit setting state automatically.
High Beam
Indicator
Fuel meter
Odometer
Speedometer
Turn Right
Signal Indicator
Turn Left Signal
Indicator