Operation Manual

16
§DISK BRAKE INSPECTION§(Applicable for model equipped with disc brake.)
y Visual check brake lines for leakage, or damage, check
brake lines connections for looseness using a wrench or
similar tool, and check whether steering handle vibration
in driving, or any parts’ interference may have damage
the brake lines. If so, bring your motorcycle to your
SANYANG dealer for repairing or service.
（leak, damaged, looseness of brake line）
（Checking front brake lining）
y check the brake from behind the brake
caliper. The brake pad must be replaced
with new lining when the brake pad wear
limit reaches the brake disk.
（Checking oil quantity in brake oil
reservoir）
y Park the motorcycle on a lever ground, and
check if fluid lever is under the “LOWER”
mark. Recommended Brake Fluid: WELL
RUN BRAKE OIL (DOT 3).
（Replenishment of front wheel brake fluid）
1.Loosen the screws and remove the master cylinder
cover.
2.Wipe clean foreign materials, dirt around the reservoir,
being careful not to let foreign materials fall into the
reservoir.
3. Remove the diaphragm plate and the diaphragm.
4. Add brake fluid to upper lever.
5.Install the diaphragm plate and the diaphragm, and
install the master cylinder cover.
6.please note the diaphragm direction, and do not let
foreign materials fall into the reservoir. And tighten the
master cylinder cover securely.
CAUTION:
y Please drive your motorcycle on a dry road
surface slowly and operate front and rear brakes
in order to find out if there is any malfunction so
as to ensure the motorcycle is at optimum
condition and safe ride. .
Brake disk
Brake
calipe
r
Brake pad wear
limit grooves
CAUTION:
y TO prevent chemical reaction, please do not use brake fluids other than those recommended.
y Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or
plastic components to prevent damage.
Screw
Master
c
y
linder cove
r
Diaphragm
Uppe
r
Brake fluid