Operation Manual

10.INSPECTION AND MAINTENANCE BEFORE RIDING
16
Check the brake from behind the brake caliper. The brake pad must be replaced with new lining when
the brake pad wear limit reaches the brake disk.
1. Loosen the screws and remove the master cylinder cover.
2. Wipe clean foreign materials, dirt around the reservoir, being careful not to let foreign materials fall
into the reservoir.
3. Remove the diaphragm plate and the diaphragm.
4. Add brake fluid to upper level.
5. Install the diaphragm plate and the diaphragm, and install the master cylinder cover.
6. Please note the diaphragm direction, and do not let foreign materials fall into the reservoir. And
tighten the master cylinder cover securely.
CAUTION:
Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or plastic
components to prevent damage.
THROTTLE VALVE HANDLE CLEARANCE ADJUSTMENT
z Correct clearance allows throttle vale handle to rotate 2~6mm.
z To adjust, first loosen the fixing nut, then turn the adjusting nut to the proper position and securely
tighten the fixing nut.
Check Items:
1. Check throttle valve cable to see if it can
be moved smoothly from a closed position
to a wide open position.
2. Rotate steering handle from side to side to
check if the throttle valve cable is interfered.
3. Check to see if the throttle valve cable is
obstructed by other cables preventing it
from being operated smoothly.
Brake caliper
Brake disk
Brake pad wear limit grooves
Master
cylinder cover
Diaphragm
Brake fluid
Screw
【ADDING BRAKE FLUID】
Upper
2~6mm
Adjust nut
Lock nut