Operation Manual

7
7. Use of each component
OPERATION OF IGNITION SWITCH
IGNITION SWITCH IGNITION SWITCH KEY
MAGNETITE KEY
：
：：
：
 Insert your magnetite key into the magnetite keyhole, and turn it to right ignition keyhole block board
can be to open.
 When close ignition keyhole. You just push the Ignition keyhole block board push rod, and ignition
keyhole can be to close.
"Start" position
• Engine can be started in this position.
• Ignition switch key can not be removed.
"Stop" position
• Engine is shut off and can not be started in
this position .
• Ignition switch key can be removed.
"Steering handle lock" position
• Turn the steering handle to left and press
ignition switch key down and then lightly turn it
to left to the “LOCK” position.
• The steering handle is locked in this position.
• Ignition switch key can be removed.
• When unlocking, simply turn the key from
“LOCK” to “OFF.”
"OPEN" position (fuel tank cap open)
：
• How to open：Insert your key into the ignition switch, and turn it to the left.
• How to lock：Push the fuel tank cap and it locks automatically.
CAUTION:
• Never operate the ignition switch key when the scooter is running. To turn the ignition switch to
“OFF” and “LOCK,” will shut off the electrical system and that may result in a dangerous
accident. Therefore, the ignition switch can only be turned off after the scooter has been
completely stopped.
• Always remove the key and be sure to take the key away with you after locking the steering
handle before leaving your scooter.
•
If ignition switch remains in the “ON” position for a prolonged period after the engine has been
stopped, the battery’s capacity will be reduced and this may affect the engine’s start ability.