Operation Manual

16
10. Inspection and maintenance before riding
【Oil Filter Cleaning】
Open the filter nut assembly of the element, and
remove the element. Remove the foreign materials
from the element by using a gasoline or air spraying
gun.
WARNING:
• Oil level will not be correct when checking the oil level with the scooter parked on an unleveled
ground or immediately after the engine stopped.
• Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to get burned
when checking or replacing engine oil.
FUEL INSPECTION
• Turn main switch key to "ON" position, and check fuel gauge's needle
range to make sure there is enough amount of fuel in the fuel tank.
• This scooter’s engine is designed for using the unleaded fuel of Octane
90 or above.
• Firmly secure the main stand on the ground, shut off the engine and
keep flames away from the scooter when refueling.
• Do not fill above fuel upper limit level when refueling.
• Make sure the fuel tank cap had been tighten properly.
TRANSMISSION OIL INSPECTION AND CHANGE
INSPECTION:
• Use the main stand to support the motorcycle on a level ground, after the engine stops, wait for 3~5
minutes. Remove the transmission oil infusion bolt, put a measuring glass under the drain bolt, and
remove the drain bolt. Let the oil flows into measuring glass and check for decreased or not.
(at disassembly: 110 cc. / at change: 90~100 cc.).
OIL REPLACEMENT:
 Stop the engine and use the main stand to support your motorcycle on a level ground. Remove the
infusion bolt and drain bolt, drain out the oil.
 Install the drain bolt and tighten it. Fill new transmission oil (90~100 cc.), and install the infusion
bolt and tighten it. (make sure that bolts are tightened and check that there’s no leakage.)
※ Recommend Oil: Genuine SYM HYPOID GEAR OIL (SAE 85W-140).
※ Use SAE85W-90 when outside temperature is below 0℃.
Fuel tank cap
Fuel tank