Manual

This function enables you to set a recording length
simply by pressing the REC/OTR button on the
TV/VCR.
Make sure ,..
• TV/VCR power must be turned on.
• Insert a cassette tape with its erase prevention tab
in place. (If necessary, rewind or last forward the
tape to the point at which you want to begin
recording.)
NOTES:
• This function CANNOT be done frorn the remote
control.
• Recording starts immediately when the REC/OTR
button is pressed.
• When the REC/OTR button is pressed 18 times, the
TV/VCR returns to the Normal Recording mode.
• To stop the OTR operation, press the STOP button
on the TV/VCR or on the remote control.
• To show the remaining time, press the DISPLAY
button on the remote control so that "OTR"
appears on the TV screen. (It will show up momen-
tarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record-
ing time, assuming the tape is started at the begin-
ning, is 8 hours using T-160 (or 6 hours using %120).
• If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode immediate-
ly, ejects the tape and turns itself off.
1 Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL • or • button.
Remember: If the TV/VCR is connected to a cable
box or satellite box, the TV/VCR must be on CH3 or
CH4, then the channel to be recorded is selected on
the cable box or satellite box.
2 Select the tape speed
Press the SPEED button to select the desired tape
speed (SP/SLP).
3 Begin OTR °[%_"__°_
Press the REC/OTR button on the
TV/VCR as many times as needed.
The recording length will be deter-
mined by the number of times you
Push(es) Display Recording length
I push normal recording)
2 pushes 0:30 30 minutes
3 pushes 1:00 60 minutes
$ 4' 4,
17 pushes 8:00 480 minutes
press the REC/OTR button. Each additional push will
increase the recording time by 30 minutes. It is set up
to 8 hours.
- 25 -
You can make copies of video tapes made by friends
or relatives tot your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an
infringement of copyright laws.
Connect your TV/VCR and a Source (Playing) VCR
using the following diagram.
[Fig.8]
NN_NNN_N n I
Audio/Video
adapter cable
(not supplied)
[Ex: Source (playing)
VCR or camcorder]
l)lnsert a pro-recorded video cassette into the Source
(Playing) VCR or camcorder.
2)Insert a blank video cassette, or one you want to
record over, into the TV/VCR's cassette compart-
ment.
3)Press the SPEED button on remote control for the
TV/VCR to select the desired recording speed
(SP/SLP).
4)Press the CHANNEL • or • button on the
TV/VCR until "AUX" appears on the screen.
5)Press the RECORD button on the TV/VCR.
6)Begin playback of the tape in the source (Playing)
VCR or camcorder.
NOTE: For best results during dubbing, use the
TV/VCR's front panel controls whenever possible.
The remote control might affect the source (Playing)
VCR's playback operation.
EN
9103