Installation Manual

def configure() {
// Device-Watch allows 2 check-in misses from device + ping (plus 1 min lag time)
// enrolls with default periodic reporting until newer 5 min interval is confirmed
sendEvent(name: "checkInterval", value: 2 * 60 * 60 + 1 * 60, displayed: false, data:
[protocol: "zigbee", hubHardwareId: device.hub.hardwareID])
// temperature minReportTime 30 seconds, maxReportTime 5 min. Reporting interval if no
activity
// battery minReport 30 seconds, maxReportTime 6 hrs by default
return refresh() + zigbee.batteryConfig() + zigbee.temperatureConfig(30, 300) // send refresh
cmds as part of config
}
def enrollResponse() {
log.debug "Sending enroll response"
String zigbeeEui = swapEndianHex(device.hub.zigbeeEui)
[
//Resending the CIE in case the enroll request is sent before CIE is written
"zcl global write 0x500 0x10 0xf0 {${zigbeeEui}}", "delay 200",
"send 0x${device.deviceNetworkId} 1 ${endpointId}", "delay 500",
//Enroll Response
"raw 0x500 {01 23 00 00 00}",
"send 0x${device.deviceNetworkId} 1 1", "delay 200"
]
}
private getEndpointId() {
new BigInteger(device.endpointId, 16).toString()
}
private hex(value) {
new BigInteger(Math.round(value).toString()).toString(16)
}
private String swapEndianHex(String hex) {
reverseArray(hex.decodeHex()).encodeHex()
}
private byte[] reverseArray(byte[] array) {
int i = 0;
int j = array.length - 1;
byte tmp;
while (j > i) {
tmp = array[j];
array[j] = array[i];
array[i] = tmp;
j--;
i++;
}
return array
}