Installation Manual

TROUBLESHOOTING
If your SMART
+
motion sensor still shows up as a “Thing,” you may need to manually apply the custom
device handler to that product. To do this:
1. Log into the SmartThings IDE.
2. Select My Devices in the top navigation.
3. Find the light bulb you just paired that came up listed as a “Thing” and select it.
4. On that device page, scroll down to the bottom and click Edit.
5. Look for the dropdown field labeled Type.
6. Click it and select the Custom Device Handler you just created. It should read SYLVANIA Smart
Motion/Temperature Sensor.
7. Select Update.
You can now rename your device and will see the correct controls listed in your SmartThings app. If
your motion sensor is no longer recognized when trying to pair, you may need to reset your motion
sensor. To do that, following the instructions found here
.