Instructions

41
12. Troubleshooting
Problem Cause Suggestion
The heater
does not
switch on.
No power to the mains
socketavailableormainfuse
defective.
Checkthepowersupplyandmainfuse.
Plug has not been fully
inserted.
Plug the power cable into the mains socket.
Thedevicewasnotswitched
ON using the main power
switch (5).
SwitchthedeviceON(5).
The room temperature is
abovethetemperatureseton
the thermostat.
Normaloperation.Deviceautomaticallyturnsonandheatsup
assoonasthetemperaturedropsbelowthesetvalue.
The day timer is active and
the current day of week is 6
(Saturday) or 7 (Sunday)
Seesection“h)SkipNextTimer”or“i)ClearaTimer”.
Overheatprotectionhasbeen
triggered.
Immediately remove any object covering the heater (if
applicable), and turn the power OFF (5).
Waituntiltheappliancehascooleddownsufciently,thenswitch
the power back ON (5).
If the heater will not power back on after cooling down, it may
be damaged from excessive heat. Turn the power OFF (5),
disconnectfromthepowersupply.Contactourtechnicalsupport
serviceorothertechnicalpersonnel.
shows on the
LED display
(10)
The temperature sensor is not
functioning correctly.
Turn the power OFF! Disconnect from the power supply
and contact our technical support service or other technical
personnel.