Instructions

ManualsBrandsSygonix ManualsBuilding Technology & Smart LivingCode lock Surface-mount IP65 + backlit keypad

Audible tone for valid user code (output is

activated)

= No audible tone

= Two short beeps

= One long beep

(Desired option) = Beep for 1 second

Access mode

= Manual access mode (the button must be pressed after entering a code)

= Automatic access mode ("Auto-entry")

Important!

In automatic access mode ("Auto-entry"), all codes must be the same length (master

code, superuser code, user codes, visitor codes and duress codes).

(Access mode) = Manual access mode

Switches the keypad/error tones on/off in normal

mode

= Audible tones are switched off

= Audible tones are switched on

(Desired option) = Audible tones are switched on

Switches the middle LED on/off in normal mode

= Flashing LED off

= Flashing LED on

(Desired option) = Flashing LED on

Settings for door opener button

= Output #1 is activated for the preset time when the door opener button is

pressed.

= The door opener will be activated 5 seconds after the door opener button

is pressed. The combination lock will beep during this period.

= The door opener will be activated 10 seconds after the door opener button

is pressed. The combination lock will beep during this period.

= The door opener will be activated when the door opener button is held

down for 5 seconds. The combination lock will beep during this period.

= The door opener will be activated when the door opener button is held

down for 10 seconds. The combination lock will beep during this period.

(Operating mode) = Output #1 will be activated for the preset time when the

door opener button is pressed.

Open door warning tone

= No warning tone

.... = Warning tone is played after 1 - 999 second delay has

elapsed

(Door open function) = Function disabled

Non-adjustable system codes:

System codes Function Input format Result

All codes and settings will be deleted and restored to the factory

defaults (except the master code), and multi-user mode will be enabled.

Enable programming mode and enter (it may take a while for the combination lock to delete

the settings).

All codes (except the master code) and settings will be deleted and restored to the factory defaults.

Enable single-user mode (you can only congure one user code for

each output, plus one visitor code and one duress code)

Enable programming mode and enter . This will delete the existing codes (e.g. user codes).

All codes (except the master code) and settings will be deleted and restored to the factory defaults. This

mode is only designed for very basic scenarios.

Exit programming mode

The combination lock switches to normal mode and waits for a valid code.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing

systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at

the time of printing.