Instructions

e) User codes

The combination lock can store up to 110 user codes (100 codes for output #1 and 10 codes

for output #2).

The following section provides an introduction on how to use codes to enable the combination

lock outputs (e.g. to release a door opener), including a number of examples.

We recommend that you create a table to record all access data (including code num-

bers, user codes and user names for outputs #1 and #2).

This will help you to monitor registered users and access permissions.

It will also make it easier to delete users and the corresponding user codes.

Saving a user code:

• The combination lock must be in programming mode (see section 12. a) for details).

• Enter the programming code for output #1 or #2:

Output 1

Output 2

• Enter a memory number.

..... 100 user codes for output 1

..... 10 user codes for output 2

• Enter the desired 4 - 8 digit user code.

Important!

When the "Auto entry" feature is enabled (see section 12. m), all codes must be the

same length (e.g. if the master code is 5 digits, the user codes must also be 5 digits).

• Press the buttontoconrmyourentry.Thecombinationlockwillbeeptwiceandthemid-

dleLEDwillashtwotimestoindicatethatthecodehasbeensaved.

• You can now create another user (press number for output #1 or number for output

#2).

• Whenyouhavenishedaddingallusers,press to exit programming mode (see section

12. a) for details).