Instructions

b) Restoring factory settings

All existing settings and programs can be deleted using a special code.

The master code will not be reset.

Proceed as follows:

• The combination lock must be in programming mode (see section 12. a) for details).

• Enter .

• Press the buttontoconrmyourentry.

• ThecombinationlockwillbeepandthemiddleLEDwillashquicklytoindicatethattheset-

tings are being deleted.

This process may take several seconds if there is a large amount of data.

• When the data has been deleted, the combination lock will beep twice and the middle LED

will stay constant to indicate that programming mode is enabled.

• All settings and programs have now been reset to the factory settings (except the master

code).

c) Setting the master code

Important!

When the "Auto entry" feature is enabled (see section 12. m), all codes must be the

same length (e.g. if the master code is 5 digits, the user codes must also be 5 digits).

The master code is used to enable programming mode (see section 12. a) for details). It cannot

be used to activate either of the outputs.

Proceed as follows:

• The combination lock must be in programming mode (see section 12. a) for details).

• Enter programing code .

• Enter the new master code (e.g. ).

• Press the buttontoconrmyourentry.Thecombinationlockwillbeeptwiceand the

middleLEDwillashtwotimestoindicatethatthemastercodehasbeensaved(theold

code will be overwritten).

Write down the new master code and store it in a safe place. If you forget the master

code, follow the instructions in section 11 to enable programming mode and set a new

code.