User manual

- 15 -
■ The diagram shows that the TV (Master)
controls the slaves: DVD player, speakers,
and light
■ If the peak drops below 35 W, power supply
to slaves is cut.
■ When the power on the master receptacle
raises to or above 35 W again, power
supply to slaves is turned back on.
Setting master and slaves
1. Navigate to the landing page.
2. Select the smart device from the device list.
3. Press
to open the device settings.
4. Press Master–Slave.
5. To select a Master tap on Master of the
respective receptacle.
6. Select a power trigger value from the
dropdown located above the PORTS.
7. To select a slave, tap on Slave of the
respective receptacle.
8. For receptacles not to be controlled by
the master, tap on Neutral of respective
receptacles.
9. Press OK to save the new settings.