Data Sheet

Pin Definition Please refer to the indication on the picture above.

The UART port pins from left to right: RXD, TXD, 5V power supply and GND.

Note: TXD and RXD are running at TTL 3.3V and are compatible with TTL5.0V

PH2.0-5PIN plug

This photo shows a typical PH2.0-5PIN plug with cable.

Caution Please carefully check power supply (5V and GND) and apply correct voltage.

Avoid connecting the module together with servos / motors using the same power

supply, as power surge may happen and consequently damage the module.

Mechanical Drawing

The following figure shows the 2D mechanical drawing of TransducerM TM200.

Unit: mm [inch]

Mounting holes: M3.

Figure 1: TransducerM TM200 Mechanical Drawing

Unit: mm [inch]