Data Sheet

You can leave the GUI running while going through the next step.

Connecting the Hardware

Using the UART Interface

The UART interface allows to either connect TransducerM to a micro-controller directly, or to a USB port of a PC through a

converter.

Please refer to the document 'TransducerM_* _Datasheet_EN_Vx-x-x.pdf' which comes along with this document for pin-to-

pin definition.

Please carefully connect and double check the power supply (5V and GND).

Reversing the polarity will damage the module.

Install TransducerM

On TransducerM, you should see axis definition similar to the one in Figure 4, Point the X-Axis to the forward direction of the

vehicle being measured. The Z-Axis of TransducerM should point to the sky when the vehicle is sitting on the ground.

The 'vehicle' being measured can be ground vehicles, flying vehicles, underwater drones or other types of movable structure.

Figure 3: GUI window

Figure 4: TransducerM Axis Definition